Audionet Amp I V2 User Manual download pdf (Page 12)

5.5 Audionet Link

For your convenience, the AMP1 V2 can be controlled remotely by one

of Audionet's multi channel pre amplifiers (e.g. MAP or MAP 1) as well

as one of Audionet's stereo pre amplifiers (e.g. PRE G2, PRE 1 G3) using

the Audionet Link interface.

You only need a optical 'Toslink' cable to connect the Audionet Link

output of your Audionet pre amplifier to the Audionet Link input IN 3

of the AMP1 V2.

In case you would like to automatically switch on/off further Audionet

units in your system (e.g. a second AMP1 V2) using the Audionet Link

interface, please connect the Audionet Link output OUT 4 of your

AMP1 V2 to the Audionet Link input of the next Audionet unit (e.g.

power amplifier, tuner, CD player etc.) using a simple 'Toslink' cable.

Note

· The 'switch on' signal is issued to any further Audionet units daisy

chained to the Audionet Link output of your AMP1 V2 with a little

delay to avoid all units switching on at the same moment, which

could cause an overload of your mains fuse.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Audionet Amp I V2 User Manual Page 12