Audionet ART G3 User Manual download pdf (Page 48)

10.2 Set Digital Output Mode

To adjust the output format of the digital outputs of the ART G3 press

key stop / set long twice. Use keys back / pause and skip / play to select

the output format.

LowBit Mode Use the LowBit mode if the ART G3 is connected to a unit

that does not support the Audionet HighBit Interface.

HighBit Mode Use the HighBit mode only if you connect the ART G3

to a unit that supports the Audionet HighBit Interface,

like Audionet DNx (except DNA 1) or Audionet

MAP 1.

disabled All digital outputs are disabled. Select this option if you

do not use any of the digital outputs of the ART G3.

Important

· If you do not need any of the digital outputs do not use any jumpers

to short-circuit the digital outputs. Instead, select disabled for op-

tion Set Digital Output Mode to switch off all digital outputs.

Please refer to the following tables to determine which digital output

format at which sample rate and resolution is available at the digital audio

outputs. The decision whether to use the HighBit or the LowBit mode

depends on the kind of digital receiver unit your ART G3 is connected to

(refer to section 'Digital output format' on page 14).

Digital Output

Mode

OUT 1 9

SPDIF

OUT 2 10

SPDIF

OUT 3 11

AES/EBU

OUT 4 14

optical

LowBit Mode

44.1kHz / 16bit

Stereo

PCM

44.1kHz / 16bit

Stereo

PCM

44.1kHz / 16bit

Stereo

PCM

44.1kHz / 16bit

Stereo

PCM

HighBit Mode

192kHz / 24bit

Stereo Upsampling

Audionet High Bit Mode

96kHz / 24bit

Stereo

Downsampling

PCM

44.1kHz / 16bit

Stereo

PCM

disabled no signal no signal no signal no signal

Tip

· On the Audionet Metal Remote Control RC 1 use setup key ä to get

to menu item Set Digital Output Mode. Use keys 9 and : to

select the digital output format.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 54

Comments to this Manuals

No comments

Audionet ART G3 User Manual Page 48

Comments to this Manuals

Related products and manuals for CD players Audionet ART G3